HP DesignJet 750C Plus Quick Reference Manual
Hide thumbs
Also See for DesignJet 750C Plus:
- Quick reference manual (33 pages) ,
- User manual (222 pages)
Related Manuals for HP DesignJet 750C Plus
Summary of Contents for HP DesignJet 750C Plus
- Page 1 All manuals and user guides at all-guides.com HP DesignJet 700 and HP DesignJet 750C Plus Plotters Quick Reference Guide...
- Page 2 All manuals and user guides at all-guides.com About This Edition Edition dates are as follows: First edition, September 1996 New editions are complete revisions of the document. Change sheets, which may be issued between editions, contain additional information. The dates on the title page change only when a new edition is published.
- Page 3 C4705‘–90041 English All manuals and user guides at all-guides.com HP DesignJet 700 and HP DesignJet 750C Plus Plotters C4507A, C4706A, C4708A C4709A...
- Page 4 All manuals and user guides at all-guides.com Contents...
-
Page 5: Loading And Unloading Media
All manuals and user guides at all-guides.com Loading and Unloading Media To Change a Roll of Media Make sure the plotter wheels are locked, by firmly pressing down the brake levers on the wheels. Remove any unused media from the media path as shown on page Remove the old roll by pulling firmly on each end of the spindle. - Page 6 All manuals and user guides at all-guides.com Rest the spindle upright on the floor with media stop (A) at the bottom Place the new roll on the spindle, so that the media’s leading edge winds clockwise, viewed from above. If the media stop (A) falls off, push it back in until it snaps into position.
- Page 7 All manuals and user guides at all-guides.com To Load Roll Media Hold the media by both edges and align its right edge with the perforated line on the entry platen. Insert the media into the plotter, until it buckles slightly. Media path 0017 When the plotter begins to pull in the media, let it go.
- Page 8 All manuals and user guides at all-guides.com When the display tells you to, lift the media lever. Take hold of the edges of the media now extending from the exit slot and pull it toward you until taut. Then align its edges with those of the roll.
- Page 9 All manuals and user guides at all-guides.com To Unload a Plot on Roll Media When you use roll media, the plotter automatically waits until the required drying time has elapsed before cutting the media and dropping the plot into the media bin. If you wish to adjust the drying times, refer to the User’s Guide.
- Page 10 All manuals and user guides at all-guides.com To Load a Sheet You can load a sheet in either portrait or landscape orientation: Note: If you are using the option (see User’s Guide), this Rotate will influence the orientation of your print. The plotter prints on the underside of the sheet.
- Page 11 Load with the matte side underneath. Clear film Load with the rougher side underneath. High-gloss photo paper* Load with the glossy side underneath. Semi-gloss photo paper* High-gloss film* *These media types are not supported by the HP DesignJet 700 plotters C4705A and C4706A.
-
Page 12: To Unload A Sheet After Plotting
Matte film Clear film recom- High-gloss photo* mended mended Semi-gloss photo* High-gloss film* *These media are not supported by the HP DesignJet plotters C4705A and C4706A. Once the drying time is over, gently pull the sheet out of the plotter. 1842... - Page 13 All manuals and user guides at all-guides.com To Remove an Unused Sheet Either ... Press Form Feed and Cut. When the plotter has finished feeding out the sheet, pull it out. Form Feed and Cut 1842a or ... Lift the media lever. Pull out the sheet.
-
Page 14: Supported Media Types
HP High-Gloss Photo Paper Semi-gloss* Semi-gloss photo paper HP Semi-Gloss High photo Photo Paper Semi-gloss paper High-gloss* High-gloss white film HP High-Gloss White High film Film *These media are not supported by the HP DesignJet 700 plotters, C4705A and C4706A. - Page 15 Display Opaque bond Opaque Matte CAD only F,N F,N,B Translucent bond Semi– Matte Nat. Tracing paper Semi– Matte CAD and HP media HP media Vellum Semi– Matte only Coated paper Opaque Matte F,N,B Heavy coated Opaque Matte paper Matte film Semi–...
-
Page 16: Clearing A Media Jam
All manuals and user guides at all-guides.com Clearing a Media Jam Switch OFF the plotter, open the window and raise the media lever. Media lever Don’t touch the stainless steel strip behind the W A R N I N G cartridge carriage;... - Page 17 (see the table on page 13) drying time—decreasing it may reduce print quality in the case of the HP DesignJet 750C Plus only, whether Sharp Lines is active or not. The use of the...
-
Page 18: Print Resolution
600 x 600 Best 600 x 600 600 x 600 600 x 600 With HP RTL and PostScript, if installed, color resolution is always 300 x 300. Addressable 600 dpi using Sharp Lines for vector graphics in HP–GL/2 plots on opaque bond, coated paper and matte film only. -
Page 19: Managing Your Plots
All manuals and user guides at all-guides.com Managing Your Plots To Use the Queue to Manage Your Plots When the option in the front-panel menus is set (the default), Queue the plotter stores your plots by page. One plot file may contain several pages. -
Page 20: To Pause While Printing A Series Of Plots
0027 To Replot or Delete a Plot In the case of the HP DesignJet 700 only, press Replot on the front panel. You can also replot a page in the queue (including a cancelled plot) by... -
Page 21: Replacing Cartridges
Press down lightly on the cartridge and pull it toward you. Lift it out of its stall. Discard it, if it is not required. Yellow Cyan Magenta Black Black DesignJet 750C Plus DesignJet 700 A dot above the stall indicates the color of the cartridge. 1119... -
Page 22: To Load A Cartridge
Press the cartridge lightly down into the stall and away from you until it snaps into place. Yellow Cyan Magenta Black DesignJet 750C Plus DesignJet 700 r004 If the front panel displays , repeat removing Reseat cartridge(s) and installing the cartridge until the message disappears. -
Page 23: The Front Panel
All manuals and user guides at all-guides.com The Front Panel To Use the Front-Panel Display Keys The front-panel display is used to show the front-panel menus and messages. For explanations of the messages, see the User’s Guide. Interaction with the display, for instance to obtain the front-panel menus, is via the display keys. - Page 24 All manuals and user guides at all-guides.com Front-Panel Menu Structure Ê Queueing & Queue mgmt= 1 ...99 Page # (nK vectors) Copies= Ê Delete page, Nesting Page #= Move to top Width=, Length= Statistics Nest= 1 min, 2 min , Optimal , In order Nest wait= ..99 min...
- Page 25 PostScript (option) Scale= HP-GL/2 352%, 400%, 419% Normal , Special 7586, HP–GL/2 Terminator= None, Less, Normal , More Drying time= Continued..Localization Note. This table contains the front-panel strings used in the front-panel menus. (All languages except KCT) Use the t of these supplied for your language.
- Page 26 Best JIS B, B1/B2–B4 Best ARCH, ARCH ARCH E1/D–A Over A2, Over A1 Notes: Oversize Inked area On DesignJet 750C Plus On DesignJet 700 Off , On Mirroring= Key: Normal , Smaller Margins= represents pressing E Defaults are indicated by...
- Page 27 All manuals and user guides at all-guides.com Where to Find Out More The following table will assist you in finding further information on the topics covered in this Quick Reference Guide and on other topics covered elsewhere in your plotter’s documentation. Where to Go to Find Further Information To Find How To ...
- Page 28 All manuals and user guides at all-guides.com...
- Page 29 All manuals and user guides at all-guides.com...
- Page 30 All manuals and user guides at all-guides.com...
- Page 31 All manuals and user guides at all-guides.com Copyright Hewlett-Packard Company 1996 Manual part number C4705-90041 First edition, September 1996 Printed in Europe Customer re-order number C4705-60021 For trademark information, legal notices, safety notices and warranty information, refer to the User’s Guide, C4705-90031. Hewlett-Packard Company Barcelona Division Avda.
- Page 32 All manuals and user guides at all-guides.com Customer re-order number: C4705–60021 Manual Part Number: C4705–90041 Edition 1, September 1996 English Printed in Europe This manual has been printed on chlorine-free bleached paper...