Installation - HP DesignJet 2500CP Service Manual

Installation

1. Lubricate the slider rod with a small amount of oil.
2. Install Y axis belt (item 5) onto the carriage assembly.
Caution: The rear bushing (item 2) on the carriage assembly is
tensioned with a spring (item 3). When installing the carriage
assembly, hold the rear bushing on the carriage assembly.
3. Making sure the Y axis belt (item 5) is between the sliding rods, slide the
carriage assembly onto the slider rods.
4. Install the trailing cable carriage clamp (item 1) in the correct position on
the carriage assembly.
5. Carefully connect the trailing cable to connectors on the carriage PCA.
6. Install two T 20 screws securing the Y axis tensioner holder to the slider
rods.
7. Install the following:
1. Y Axis Belt ' page 8 39.
2. Encoder Strip ' page 8 32.
3. Service Station Flag ' page 8 26
4. Right Hand Cover ' page 8 21.
5. Window and Top Cover ' page 8 15.
6. Left Hand Cover ' page 8 18.
8. Install the power cable and turn the printer on in service mode.
9. Perform the following calibrations.
1. C01 Carriage ' page 5 6
2. C02 Refill ' page 5 8
3. C03 Line Sensor ' page 5 9
4. C05 Printheads Alignment ' page 5 12
5. C06 Printheads Check ' page 5 13
6. C07 Color Calibration (Only for HP DesignJet 2500CP/3500CP
printers ' page 5 15
7. C08 Service Accuracy ' page 5 16
Removal and Installation
HP DesignJet CP Series Printers
8-43