HP DesignJet 2500CP Service Manual page 75

Message Explanation and Action
MIXED INK The printer has earlier detected components of different ink system types (for
example, Imaging and UV Pigmented). Printing will be disabled until the ink
SYSTEM
88xxxx systems are all of the same type. The error code "88xxxx" indicates a mixed ink
system error.
Press the Replace Ink System key to replace the erroneous ink systems in order
to print with your printer again. You can press the Enter key to access the main
front–panel menu.
No code for UV The printer does not have the correct firmware for the HP DesignJet CP ink
inks system UV currently installed.
Continue levels A.01.xx.)
Press
system) back into the printer.
Access the menu Utilities / Statistics / Code rev to confirm the firmware revision
present. If you have a code revision like A.01.xx, you need to upgrade your
firmware to code revision A.02.08 or higher to use the HP DesignJet CP Ink
System UV.
Open left door to You are doing an ink system replacement.
access ink cartrg.
Open the left door to access the ink cartridges.
Open right door to You are doing an ink system replacement.
access head cleaners
Open the right door to access the printhead cleaners.
Open window to You are doing an ink system replacement.
access printheads
Open the window to access the printheads.
Out of disk space (HP DesignJet 2500CP/3500CP only) The current print file is too large for the
Data was lost printer's memory.
Try lowering the resolution of the file you are attempting to print, or otherwise
reducing its complexity.
OUT OF INK The printer has detected that the amount of ink in the ink systems indicated
JJ-J
by one or more flashing squares, is below acceptable limits for satisfactory
printing.
Press
Out of memory The current file is too large for the printer's memory; the printer has run out of
Data was lost disk space for processing the file.
To print files of this size, you may need to install more memory to your printer.
Press ENTER when The printer is waiting for you to confirm an action or selection.
done
When you have taken the appropriate action press the
User Messages
(This message only applies to firmware revision
to continue, and reinstall the HP DesignJet CP Ink System (Imaging ink
to check the indicated ink systems.
HP DesignJet CP Series Printers
Enter key.
3-9