Rollfeed Cover Assembly Removal - HP C2858A Service Manual

Drafting plotters
Hide thumbs Also See for C2858A:
Table of Contents

Advertisement

ROLLFEED COVER ASSEMBLY REMOVAL

To remove the rollfeed cover assembly, perform the following procedure:
1. Lower and hold the rollfeed cover about halfway open.
W A R N I N G
2. Using a TORX T-10 screwdriver, remove the screws and washers that attach the left
and right springs to the pivot spring anchor pins. See Figure 6-21.
3. Using a 7 mm wrench, loosen the two nuts that secure each end of the rollfeed cover
to the pivots.
4. Pull the rollfeed cover clear of the plotter.
(C)C2858-37
Left Pivot Spring
Anchor Pin Screw
Removal and Replacement
6-30
Download Free Service Manual and Resetter Printer at http://printer1.blogspot.com
While removing each screw in step 2, relieve the spring
tension slightly by holding the spring with one hand to
avoid possible personal injury.
Nuts
(2 each side)
Figure 6-21.
(C)C2858-38
Right Pivot Spring
Anchor Pin Screw

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2859a

Table of Contents