4
Grasp the Belt, insert it between the Belt
Stopper, and affix the Belt Stopper with a hex
screw at the position indicated.
• Here, the Belt Stopper is the one that was removed and stored after initial installation.
Important
• Do not touch the Linear Scale (a),
5
Close the Top Cover.
6
Tape down printer covers to secure them, in the reverse order of tape removal during installation.
7
Remove the Output Stacker by reversing the installation procedure.
Neglecting to attach the Belt Stopper may damage the printer.
Carriage Shaft (b), or Fixed Blade (c).
This may stain your hands and damage
the printer.
iPF8400S Basic Guide
81