Download  Print this page

The Size Of Clear Film Cannot Be Detected; Margins Are Wide - Canon IPF8400S Basic Manual

Large format printer.
Hide thumbs

Advertisement

Table of Contents
Cause
The Media Take-up Sensor cord is not connected to the
Right Media Take-up Unit correctly.

The size of clear film cannot be detected

Cause
The Platen is soiled with ink or other substances.

Margins are wide

Cause
Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
When Cutting Mode in the Control Panel menu was set to
Manual, you selected Do not perform in response to the
Perform the detection of paper leading edge? message.
Corrective Action
Reconnect the Media Take-up Sensor cord as follows.
1. Turn the printer off.
2. Disconnect the Media Take-up Sensor cord from the
Right Media Take-up Unit and reconnect it firmly, all the
way in.
3. Turn the printer on.
(See "Using the Media Take-up Unit (Optional).")➔User's
Guide
If the Media Take-up Unit continues rotating, contact your
Canon dealer for assistance.
Corrective Action
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")➔P.56
Corrective Action
This operation is normal.
Set Cutting Mode to Manual again, and select
Perform(recommend) when the Perform the detection of
paper leading edge? message is displayed.
Note that when you select Perform(recommend), if the
paper is strongly curled, the Printhead may rub against the
leading edge of the paper when the printing starts.
(See "Specifying the Cutting Method for Rolls.")➔User's
iPF8400S Basic Guide
109

Advertisement

Table of Contents

   Also See for Canon IPF8400S

Comments to this Manuals

Symbols: 0
Latest comments: