Printer Relocation Preparing To Transfer The Printer - Canon IPF8400S Basic Manual

iPF8400S Basic Guide
Printer Relocation
Preparing to Transfer the Printer
Preparing to Transfer the Printer .................................................................................................................... 76
Reinstalling the Printer ................................................................................................................................... 82
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow these steps before transferring the printer to a
new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
• Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may
leak and damage the printer if you do not prepare the printer correctly and it is tipped or stood
Important
on end in transit.
• Depending on the state of the printer, part replacement may be necessary when preparing to
transfer the printer (that is, when you execute the printer menu item to prepare for transfer).
Note
• Ink must be drawn into the Maintenance Cartridge before Level 2 or Level 3 printer transfer, as
described in the following table. Prepare the Maintenance Cartridge in advance.
• Always follow the instructions of the service representative when transferring the printer under
Level 3 conditions.
1
2
3
*1: This is the number of new Maintenance Cartridge required when you execute the Prep.MovePrinter
*2: If a message instructing you to replace the Maintenance Cartridge is displayed on the Display
Remove paper
1 Remove the paper.
• Rolls (See "Removing the Roll from the Printer.")➔P.18
76
Level Shipping Method
(Example)
By truck
By plane
Tipping the printer or
holding it upright for
elevators or stairs
menu. The number varies depending on the amount remaining in the Maintenance Cartridge being
used.
Screen, the Maintenance Cartridge needs to be replaced.
Permitted Angle of Amount of Ink to
Inclination Dispose of
Lengthwise: 0–30º 0
Rotation: 0–10º
All directions: 0–30º Approx. 1.8 L
(60.9 fl oz)
Lengthwise: 0–90º Approx. 1.8 L
(60.9 fl oz)
Rotation: 0–30º
Required Maintenance
Cartridges(*1)
0(*2)
2 or 3
2 or 3