Configuring The System For Snmp Management - RADVision SCOPIA XT5000 Series Administrator's Manual

Step 3
Step 4

Configuring the System for SNMP Management

Integration with SCOPIA iVIEW Management Suite allows remote monitoring, configuring,
upgrading and control features of SCOPIA XT Series endpoints, using SNMP (Simple Network
Management Protocol) and an AT command-based protocol on TCP/IP. In particular, these
features have been introduced:
Before you begin
Ensure you have the IP addresses and the subnet mask of the computers which you want to
use for remote management of SCOPIA XT Series.
Procedure
Step 1
Step 2
RADVISION | Administrator Guide for SCOPIA XT5000 Series Version 3.0
Set the fields as required.
Field Name
AT commands
management
Enable all addresses
Address
SubNet mask
Press Save.
•
Monitoring - SCOPIA iVIEW Management Suite can request identification and access
capabilities from the endpoint.
•
Status traps - SCOPIA iVIEW Management Suite is able to detect if the terminal is turned
on, and its call status.
Access the SCOPIA XT Series web interface.
In the Administrator settings tab, select Utilities > Remote Access > SNMP.
Description
Enables/disables AT command API for remote control.
If set to Yes, enables access to the XT Codec Unit from any IP
address in a network. If set to No, configure Address and
SubNet mask.
Enter the IP address allowed to access the system.
Enter the SubNet mask associated with the IP address.
Maintenance Tasks | 21