Configuring The System For Snmp Management - RADVision SCOPIA XT1000 Piccolo Administrator's Manual

Procedure
Step 1
Step 2
Step 3
Step 4

Configuring the System for SNMP Management

Integration with SCOPIA iVIEW Management Suite allows remote monitoring, configuring,
upgrading and control features of SCOPIA XT Series endpoints, using SNMP (Simple Network
Management Protocol) and an AT command-based protocol on TCP/IP. In particular, these
features have been introduced:
RADVISION | Administrator Guide for SCOPIA XT4000 Series Version 3.0
Access the SCOPIA XT Series web interface.
In the Administrator settings tab, select Utilities > Remote access > AT Commands.
Figure 2-9
Set the fields as required.
Field Name
AT commands
management
Enable all addresses
Address
SubNet mask
Press Save.
Configuring AT commands
Description
Enables/disables AT command API for remote control.
If set to Yes, enables access to the XT Codec Unit from any IP
address in a network. If set to No, configure Address and
SubNet mask.
Enter the IP address allowed to access the system.
Enter the SubNet mask associated with the IP address.
Maintenance Tasks | 21