Pairing An Xt Remote Control Unit With A Xt Codec Unit - RADVision SCOPIA XT4000 Series User Manual

Use the XT Remote Control Unit to navigate through system menus, as follows:
Note

Pairing an XT Remote Control Unit with a XT Codec Unit

Multiple XT Codec Units can be set up in the conference room and controlled with different XT
Remote Control Units.
Each XT Remote Control Unit is dedicated to one XT Codec Unit by pairing them. This is done
by configuring the same numeric code in your XT Remote Control Unit and the system
software.
An XT Remote Control Unit is configured with code 01 by default.
Before you begin
Decide what numeric code you want to use for your monitor and the XT Codec Unit. You can
choose any value between 1-99.
Procedure
Step 1
RADVISION | User Guide for SCOPIA XT4000 Series Version 3.1
•
Scroll through menus and options using the arrow keys and pressing the ok key.
Use the ok key to select an item or a specific option, such as when choosing the
interface language. If there are less than 5 options in a list, press ok repeatedly to
scroll through the options.
•
Use the XT Remote Control Unit keypad to enter letters and digits. The current input
method is displayed in the field you are in:
The default input method is abc1: you must press the required character key on the XT
Remote Control Unit repeatedly before entering a digit. To enter text in the XT Series
interface, scroll to the input field and enter the required characters.
You can also select another input method that best suits the type of information you want
to enter by pressing
displayed. Press repeatedly to switch between ABC, abc, or 123 input methods.
Access the general settings, as follows:
•
From the web interface, navigate to:
Basic Settings > General.
•
From the endpoint itself, access the Main menu and navigate to:
Configure > General.
while the cursor is in the input field. The input methods are
Getting Started | 5