Enabling At Commands For Managing The Xt Codec Unit - RADVision SCOPIA XT1000 Piccolo Administrator's Manual

Step 3
Step 4
Note

Enabling AT Commands for Managing the XT Codec Unit

You can manage the XT Codec Unit from a computer using AT messages over a TCP/IP
connection. The AT messages can be used for:
The message exchange between the XT Codec Unit and the PC is based on ASCII characters.
Messages are sent over a TCP socket to port 55003 of the XT Codec Unit.
Before using this functionality, you must enable AT command management in the SCOPIA XT
Series. Ask customer support for information on how to use AT commands.
Before you begin
Ensure you have the IP addresses and the subnet mask of the computers which you want to
use for remote management of SCOPIA XT Series.
RADVISION | Administrator Guide for SCOPIA XT4000 Series Version 3.0
Figure 2-8 The USB ports on the rear panel of the SCOPIA XT Series
The upgrade procedure begins automatically.
Follow the instructions displayed on the screen.
The system restarts automatically after the upgrade procedure is completed.
Wait for two minutes to ensure that the upgrade procedure is completed.
The upgrade procedure may automatically continue after the reboot.
Do not turn off the SCOPIA XT Series before the upgrade procedure is completed.
•
Initialization
•
Configuration
•
Call control and multipoint control
•
Control and indication
•
Diagnostics
Maintenance Tasks | 20