Pairing An Xt Remote Control Unit With A Xt Codec Unit - RADVision Scopia XT Executive User Manual

Pairing an XT Remote Control Unit with a XT Codec Unit

Perform this procedure if there are multiple Scopia XT Executive endpoints in the same room.
Each XT Remote Control Unit is dedicated to one XT Codec Unit by pairing them. This is done
by configuring the same numeric code in your XT Remote Control Unit and the system
software.
An XT Remote Control Unit is configured with code 01 by default.
Before you begin
Decide what numeric code you want to use for your monitor and the XT Codec Unit. You can
choose any value between 1-99.
Procedure
Step 1
RADVISION | User Guide for Scopia XT Executive Version 3.1.1
You can also switch between ABC, abc, and 123 input methods by pressing 1/a/A
repeatedly while the cursor is in the input field.
Access the general settings, as follows:
•
From the web interface, select Basic Settings > General.
•
From the endpoint's Main menu, select Configure > General.
Getting Started | 19