Disassembling The Carburetor - KTM 2003 950 Adventure Repair Manual

1
3
6
bl
bk

Disassembling the carburetor

2
– Loosen the throttle linkage arm
shims.
– Unscrew the throttle sensor and cable for the idle setting.
– Loosen the screws and remove both connecting rods
2
NOTE:
– The screws on the connecting rods are glued in. Place the carburetor
on an aluminum plate and tap the screws carefully with a hammer
to loosen.
– The fuel connections must be turned aside before the connecting
rods can be removed.
– Unscrew the connection for the electric starter system
remove the starter piston and spring, unless already removed when
the carburetor was dismounted.
5
– Pull the fuel connection
– Remove the diaphragm cover
4
– Remove the throttle slide spring
5
of the carburetor together with the diaphragm.
7
– Press the jet needle holder
carefully unclip from the jet needle and remove.
8
NOTE: the spring
holder.
– Check all parts for wear, especially the jet needle and the guide
surfaces
– Check the throttle slide diaphragm carefully for cracks or fractures.
NOTE: the tab of the throttle slide diaphragm contains a small air jet
9
– be carefully not to lose it.
bl
1
out of the carburetor.
4
.
5
and pull the throttle slide
6
together in the direction of the arrows,
8
on the jet needle usually remains in the jet needle
9
of the throttle slide.
bk
8-4
and remove together with the
.
2
and
3
7
out