Adjusting The Float Level; Adjusting The Idle Mixture Control Screw - KTM 2003 950 Adventure Repair Manual

2
3
5
6
– Position both connecting rods
1
NOTE: bend the fuel connections according to the recesses in the
connecting rods before mounting the connecting rods.
1
– Mount the throttle linkage arm
NOTE: slide the curved plastic shims
– Screw on the throttle sensor and cable for the idle setting.
2

Adjusting the float level

NOTE: it is not necessary to separate the two carburetors to adjust the
float level.
– Remove the float chamber.
4
– Turn the carburetor aside until the float
– Place the setting gauge 600.29.016.000
– Mount the float chamber.

Adjusting the idle mixture control screw

NOTE: the idle mixture control screw can only be adjusted when the
carburetor is dismounted.
– Screw the mixture control screws in to the limit.
– Screw out the mixture control screws 2 1/4 turns (see Technical
Loctite 243 and mount.
drawing and secure with the pins.
See page 8-11 to adjust/check the throttle sensor.
See Chapter 12 to adjust the idle speed.
See Chapter 12 to synchronize the carburetor.
See page 8-11 to adjust the throttle cable.
the needle valve.
the highest part of the float. The setting gauge should not press
against the float but there should not be a gap between the setting
gauge and the float. If necessary, bend the arm on the float and
check again.
Specifications).
, coat the thread of the screws with
1
with shims as shown in the
2
on the bolts first.
3
presses lightly against
4
on the carburetor at
5
8-10