Removing The Engine - KTM 2003 950 Adventure Repair Manual

2
1
3
3
3
5
5
6
6
5
5
9
8
bk

Removing the engine

– Screw the center stand 600.03.022.000 onto the frame
– Remove the left bump rubber and lock the center stand with the
NOTE: if available, use the center stand already on the bike.
– Unlock the seat lock with the ignition key and remove.
1
– Remove the bolts
4 – Open the tank cover, unscrew the fixing bolts
4
– Remove the bolts
– Close the fuel cocks, disconnect the gasoline hoses, unscrew the
NOTE: it is easier to disconnect the gasoline hoses if you remove the
front bolts on the underride protection and fold the engine guard down.
7
– Drain the engine oil from the oil tank and the engine: see Chapter 12.
– Remove the 4 bolts
– Remove both bolts
8
– Open the lid on the battery compartment and disconnect the battery
– Take out the battery and remove the upper battery cover.
bk
up the motorcycle on a firm, even surface.
lock 600.29.055.000 .
2
on the left and right of the front side covers,
3
disconnect the front turn signal, pull the tank vent hoses off of the
fuel tank and remove the side covers.
upper tank compartment.
on the lower tank compartment and the fuse
5
box, take the cover off the fuse box and dismount the lower tank
compartment.
upper and lower fixing bolts on both fuel tanks and remove the
6 7
tanks together with the lower vent hoses.
on the underride protection and take off the
8
underride protection.
on the front cover and take off the cover.
9
terminals (starting with the negative pole).
bk
3-2
and jack
1
and remove the
4