Preassembling The Spreader Drive - KTM 2003 950 Adventure Repair Manual

1
1
3
4

Preassembling the spreader drive

NOTE:
– The tension spring bolts must be attached as illustrated.
– The other holes
– Attach the tension spring bolts
the tension spring into the recess of the drive wheel.
2
– Mount the tensioning wheel so that the tension spring bolts engage
in the right hole
NOTE: gently press together with your fingers.
– Mount the preassembled spreader drive on the lower part of the
pretensioning tool 600.29.050.000, making sure the pin on the
tool engages in the groove in the drive wheel.
– Screw on the nut and washers for the balancer shaft to prevent the
spreader drive from falling apart.
– Clamp the lower part 600.29.050.000 with the flat areas in a vise.
– Apply the pretensioning tool hook wrench 600.29.051.000 to the
tensioning wheel and turn against the spring until the pin can be
inserted in the hole.
NOTE: the preload is approximately one tooth gap.
are used to block the spreader drive.
1
in the drive wheel
2
and then press the two gears together.
4
5-14
and press
3