KTM 2003 950 Adventure Repair Manual page 39

1
3
6
7
8
8
– Mount the front oil line
NOTE: up to engine number 2-600-1186 a washer must be used to
preload the O-rings on the oil terminal.
– Align the side supports and battery case against the engine, insert
– Mount the bolts
3
– Tighten the nut on the swing arm pivot to 130 Nm.
– Connect the fuel hose
4
2
– Run the positive starter cable to the starter and screw on the starter
5
– Attach both starter relay connectors
– Run the gasoline pump vent hose
I
F YOU RUN THE HOSE STRAIGHT UP WITHOUT AN ARCH
PENETRATE
– Screw on the ground wire
5
– Attach the connector
– Slip on the hose from the engine ventilation
9
8
inserting new O-rings. Tighten the bolts.
1
the bolt and mount the nut.
2
(M10x23), lifting the engine slightly if necessary.
3
Tighten the nut and bolts to 45 Nm.
and fasten with a cable clip.
4
engine. Run the starter ground to the battery case.
harness to the engine bracket and back down, forming an arch see
Technical Information, Chapter 1.
! CAUTION
,
CAUSING THE GASOLINE PUMP TO BE SOILED AND DAMAGED
7
.
8
Öttiker clamp with the special pliers 600.29.057.000.
.
5
upwards along the wiring
6
!
,
WATER WILL BE ABLE TO
from the regulator.
and mount the new
9
3-8
.