Injection System; Dismounting/Mounting The Throttle Body; Dismounting/Mounting Fuel Pump With Pressure Regulator/Level Sensor; Replacing The Fuel Filter - KTM 2003 950 Adventure Repair Manual

8-13
2
3
6
7
bk

INJECTION SYSTEM

Dismounting/mounting the throttle body

(see Chapter 3)
NOTE: never carry out any work on the throttle body; no adjustments
are necessary.
1
Dismounting/mounting the fuel pump with pressure regulator
and fuel level sensor
– Disconnect the fuel line. To disconnect, press down lightly on the
metal shim
– Remove the tank side covers, remove the front tank screw,
disconnect the bleeder line and fold up the tank.
5
– Disconnect connector
loosen the screws
– Loosen the screws
of the tank.
4
– Remount in the reverse order, always replacing the O-rings
(lubricated with engine oil) for the fuel pump and fuel connector.

Replacing the fuel filter

8
NOTE: no prescribed changing interval but recommended if soiled.
– Remove the fuel pump (see above).
– Press the retaining clip
7
upper part with the pressure regulator
– Remove and replace the fuel filter
– Position the spring
9
and press tightly until the retaining clip engages.
bl – Mount the fuel pump (see above).
and pull the connector off.
1
, remove the lock ring
2
and lift off the tank.
4
on the fuel pump and pull the fuel pump out
5
towards the outside and pull off the
7
8
and O-ring
9
in the upper part, mount on the fuel pump
bl
from the damper,
3
6
.
.
bk