KTM 2003 950 Adventure Repair Manual page 34

3-3
1
4
7
2
3
4
5
6
8
– Unscrew the bolts and remove the intake snorkel
1
the frame from the air filter box.
– Disconnect the vent hose and the EPC hose and remove the upper
half of the air filter box.
– Turn the intake trumpet
Remove air filter.
– Unbolt both side covers on the lower air filter box and remove the
clamps on the carburetor connection boot.
– Detach the EPC hoses
4
out of the lower air filter box.
– Remove both vent hoses from the carburetors.
– Lift both carburetors, carefully draw the cable for the idle speed
adjustment and the gasoline hose through the openings in the lower
air filter box.
– Detach the fuel hoses from the carburetors.
– Pull the carburetor connection boots off of the intake manifolds.
– Detach the SLS valve
5
thin hose from the intake manifold and the thick hose from the
valve. Remove the valve.
– Remove the EPC valve
disconnect.
– Tilt up the carburetors and fasten to the handlebar with a wire or
rubber band. They do not need to be completely dismounted.
– Take the lower air filter box out of the frame.
NOTE: cover the intake ports with a cloth to prevent any parts from
falling inside.
– Unscrew both nuts on the front exhaust manifold flange on the
7
cylinder head, loosen the exhaust clamp
manifold, pull the front exhaust manifold out of the rear exhaust
pipe and remove.
– Unscrew the rear exhaust manifold from the cylinder head.
2
in a clockwise direction and remove.
3
from both carburetors and pull the hoses
from the lower air filter box, pulling the
from the lower air filter box and
6
on the front exhaust
8
together with