Adjusting The Throttle Cable For Models With Fuel Injection - KTM 2003 950 Adventure Repair Manual

1
2
3
5
7
6

Adjusting the throttle cable for models with fuel injection

NOTE: to adjust the throttle cable clearance, the throttle valves must
be closed. To close, retract the idle speed control stepper motor all the
way using the KTM diagnostics tool.
If this step is omitted, the throttle cable clearance cannot be correctly
adjusted.
– Connect the KTM diagnostics tool, turn the ignition switch on and
start the program.
– Select "Extend"
– Select "Device operation"
– Enter your password.
– Select "Idle speed control stepper motor"
window with the arrow
4
– Acknowledge with "Execute"
motor will be completely retracted and the throttle valves completely
closed.
– Remove the left side cover on the air filter box and check whether
the throttle valves are completely closed.
– Switch the ignition switch off and adjust the throttle cable clearance
as follows:
– Loosen the counter nut
and tighten the counter nut again.
NOTE:
– You should be able to feel 3-5 mm play in the throttle grip when you
start to turn it.
– Make sure the throttle grip returns to the neutral position
automatically when released.
– Turn the ignition switch on again, exit the program, turn the ignition
switch off and disconnect the KTM diagnostics tool.
To check whether the setting is correct, start the engine, steer left and
right all the way to the stop. The idle speed should not change.
.
1
.
2
3
.
4
. The idle speed control stepper
5
, turn the adjusting screw
6
2-12
and move to the right
as needed
7