KTM 2003 950 Adventure Repair Manual page 105

1
2
3
5
Camshafts cylinder rear
– Insert the two camshafts marked "in re" (rear intake camshaft) and
NOTE:
– The same camshaft gears are used in both cylinders but they have
– The cams
– The camshaft bearing bridges
1
– Place plastigauge measuring strips
– Carefully mount the camshaft bearing bridge and tighten the bolts in
– Tighten to 18 Nm (M8) and 10 Nm (M6) in the second stage.
4
W
HEN TIGHTENING THE BOLTS OF THE CAMSHAFT BEARING BRIDGE
THAT THE VALVES ARE NOT ACTUATED BY THE CAMSHAFT
OTHERWISE THE BEARING BRIDGE WILL BREAK
NOTE: do not turn the camshafts.
– Remove the camshaft bearing bridge again and compare the width
6
– Carefully mount the camshaft bearing bridge and tighten the bolts in
– Tighten to 18 Nm (M8) and 10 Nm (M6) in the second stage.
"ex re" (rear exhaust camshaft) into the bearings without tilting. The
marks on the camshaft gears must coincide with the flat outer
surface of the cylinder head (see illustrations).
marks for cylinder rear and front. Use the camshaft gear marked
with a cross for cylinder rear and the camshaft gear marked with
1
a circle for cylinder front.
of both camshafts on the cylinder rear will point
2
towards the inside in the TDC position.
coinciding marks to ensure that the same camshaft bearing bridge is
mounted on the same cylinder head.
camshaft bearing positions.
the camshaft bearing bridge to 10 Nm (M8) in the first stage.
! CAUTION
of the plastigauge measuring strip
packing. The width of the plastiguage measuring strip is equivalent
to the bearing clearance.
Camshaft bearing clearance: 0.020 mm – 0.061 mm
Wear limit: 0.09 mm
the camshaft bearing bridge to 10 Nm (M8) in the first stage.
and the cylinder heads
3
(600.29.012.000) on the
5
!
,
MAKE SURE
(
SEE ILLUSTRATION
.
with the information on the
6
6-16
have
4
),