KTM 2003 950 Adventure Repair Manual page 42

3-11
1
3
2
4
4
5
5
4 4
8
8
8
bk
bl
– Fit the upper battery cover and place a battery with battery cover
– Fit the front battery compartment lid and connect both battery
– Close the front battery compartment lid.
1
– Mount the underride protection, apply Loctite 243 to the 4 bolts
– Mount the front cover, apply Loctite 243 to both bolts
2
– Mount the lower tank compartment and screw on the fuse box
– Fill cooling liquid into the radiator, compensating tank and engine:
– Fill engine oil: see Chapter 12.
– Connect the fuel sender to the right tank. Connect the gasoline and
7
– Screw in the upper
6
– Connect the front turn signal and attach the vent hoses to the tanks.
– Mount the upper tank compartment and fasten with the bolts
– Close the tank compartment lid and mount the seat.
9
9
– Remove the center stand lock
– Check all hose connections for leakage before you take a trial run.
– Check all hoses, lines and cables for a proper fit.
into the battery compartment.
cables together to the connections on the front lid (start with the
1
positive cable).
(M8x14 collar bolts) and tighten to 25 Nm.
and tighten to 25 Nm.
Mount the fuse box cover.
see Chapter 12.
vent hoses and mount the tanks.
(M8x40) and lower
5
fixing bolts and open the fuel cocks.
Fasten both side covers with the bolts
bump rubber and remove the center stand
3
(M8x55) or
6 7
and tighten.
8
600.29.055.000, remount the left
bk
.
bl
2
(M8x16)
.
4
(M8x50)
.
9