Ecu 950 Adventure/Supermoto/Super Enduro; Checking The Pulse Generator 950 Adventure/950 Supermoto - KTM 2003 950 Adventure Repair Manual

1
2
3
3

ECU 950 Adventure/Supermoto/Super Enduro

Check the cables and socket connectors on the ECU
Adventure) and (950 Supermoto/Super Enduro).
2
A functional check of the ECU can only be performed on an ignition
test stand.
– Check the ignition coil control: remove the ignition coil connector
and apply the measuring tips of the peak voltage adapter to the pins
of the connector AS (see checking the ignition coils).
– Actuate the tip switch and let the starter engine run for a few
seconds
Multimeter reading: 12 volts
!
N ECU
EVER TEST THE WITH A CONVENTIONAL MEASURING DEVICE
DESTROY HIGHLY SENSITIVE ELECTRONIC COMPONENTS

Checking the pulse generator 950 Adventure/950 Supermoto

– Disconnect the connectors AL and AT and apply the measuring tips
of the peak voltage adapter to the connector AT
yellow/white cable colors).
– Actuate the tip switch and run the starter engine for a few seconds.
Digital multimeter reading: 4.0 volts +/- 0.5 volts
NOTE: make sure the battery is fully charged.
– If the measured value deviates from the set point value, measure the
resistance of the pulse generator:
190 - 300
NOTE: if the resistance figure is correct but the signal voltage deviates,
check the distance between the pulse generator and the pulse
generator wheel (see Chapter 6).
CAUTION !
.
(yellow/blue and
3
Ω
at 20°C
7-16
(950
1
.
THIS MAY