Christie roadie 25k User Manual page 64

OPERATION
3-10
Roadie 25K User's Manual
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 5
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
to display from the other Dual SD/HD-SDI Module input.
NOTE: Access to Input 7 requires projector software v1.1 or higher.
Input 6
Input 6
Press to display from the
Input 6
If the Dual SD/HD-SDI Module is installed here, and there are two inputs connected,
its second input (B) is considered
. Or, if you are using the built-in keypad or the optional "lite" remote keypad,
neither of which have a separate
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 6
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
to display from the other Dual SD/HD-SDI Module input.
NOTE: Access to Input 8 requires projector software v1.1 or higher.
Input
Input
Input n
Enter (where n = 1, 2, 3, 4, 5, 6, 7 or 8) as an alternative method for
selecting which source to display. Six source locations are identified with input
numbers on the projector's input panel. The last two, 7 and 8, require the Dual
SD/HD-SDI Module installed in either of the option slots and can be accessed with
software v1.1 or higher.
NOTE: key behavior depends on whether or not the Display Channel List
Input
option is selected in the Menu Preferences menu. You can choose to have on-screen
feedback when you press
"blind", i.e. without on-screen feedback. See Menu Preferences.
Contrast
Cont
Press to change the amount of white in your images. Use
Cont
you reach the desired level of white—for best results, start low and increase so that
whites remain bright but are not distorted or tinted, and that light areas do not
become white (i.e., "crushed"). Conversely, low contrast causes dim images. See 3.7
Adjusting the Image (Image Settings subsection).
Brightness
Bright
Press to increase or decrease the amount of black in the image. Use
Bright
keys until you reach the desired level of black—for best results, start high and
decrease so that dark areas do not become black (i.e., "crushed"). Conversely, overly
high brightness changes black to dark gray, causing washed-out images. See 3.7
Adjusting the Image (Image Settings subsection).
INPUT 5
INPUT 6
interface module installed in the Option 2 slot.
INPUT 8
and can be most easily accessed with
INPUT 6
key, use
Input
INPUT 6
, press
Input 6
INPUT 6
, or you may prefer to enter the desired source location
Input
INPUT 7
or , depending on which of
INPUT 8
to access as follows:
again. This switches to
INPUT 8
or , depending on which of
keys until
again
Input 5
Input
INPUT 8
.
again
Input 6