Christie roadie 25k User Manual page 82

OPERATION
PIP Enable
Toggle to display from two sources at once (picture-in-picture) or the primary source
only. This checkbox turns the secondary source on and off in the display. Note: Not
available in v1.0 software. Shown as "Reserved".
Advanced Size and Position
— SUBMENU
This submenu consists of the
following options:
ACTIVE INPUT WINDOW:
This
read-only value indicates the
current size (i.e., area) of your
displayed data or "region of
interest" as defined by the
blanking controls. For example, if
you have blanked (cropped) 100 pixels from both the left and right edges of an
incoming source of 2048 x 1080, the remaining active input window will be 1848 x
INPUT 3 INPUT 4
1080. When using a video source at or , the default blanking of "0"
defines an active input window of 720 x 483.
BLANKING (TOP, BOTTOM, LEFT, and
RIGHT):
Crop the image as desired so
that unwanted edges are removed from
the display (changed to black—see
right). Blanking defines the size of the
Active Input Window, creating an area
of interest. Range of adjustment
depends on the source resolution and
other factors for your application.
PLUG & DISPLAY (EDID):
By default, a Plug & Play (EDID)
source outputs a signal according to the EDID information
provided by the projector. To override this information and
display in a different format (for example, if your Plug &
Play [EDID] device does not support the projector's
resolution and/or frequency), select the desired Plug & Play
(EDID) resolution from the list.
Any daisy-chained projectors will also display according to
the chosen Plug & Play (EDID) format.
EDID = Extended Display Identification Data standard.
3-28
Roadie 25K User's Manual