Christie roadie 25k User Manual page 52

INSTALLATION AND SETUP
Remote Keypad
Protocols
2-46
Roadie 25K User's Manual
Figure 2.51. Independent Keypads and Projectors
'
The Roadie 25k's standard IR remote keypad can be set to one of seven different
protocols, "A" through "G". To change protocol in the remote, follow Steps 1
through 4.
NOTE: Protocols B-G are not supported in v1.0 software. Use "A" or "Wired" only,
both of which can be turned on or off.
Step 1
Unlatch and open the battery compartment on the back of the keypad as shown in
Figure 2.52.
Step 2
Find the 4 jumpers located along the latching side of the battery compartment. These
jumper settings establish the remote keypad protocol so that the remote functions in a
certain manner.
Step 3: Set the Jumpers
Set the jumpers to match one of the protocols shown in Figure 2.53. Use tweezers or
needle-nose pliers to remove and replace each jumper as necessary.
• J1 jumper: Set between 1 and 2 or 2 and 3 as required for the desired protocol.
Figure 2.52. Opening the Remote