Christie roadie 25k User Manual page 135

STEP 16
Filter Replacement
Procedure
BEFORE YOU BEGIN
STEPS 1-2
STEPS 3-4
STEPS 5-6
LampLOC ensures maximum brightness, with the lamp well-centered with its
reflector and distanced correctly from the rest of the illumination system. Refer to
3.9, Working with the Lamp for details.
Record the serial number of the new lamp
'
1. In the Lamp menu, select "Change Lamp".
2. In the Lamp S/N text box, enter the serial number.
3. Press
and to reset the lamp timer. The timer will now begin to log time for the
new lamp.
'
Replace the air filter whenever the lamp module is replaced, or more frequently if
operating the projector in a dusty or dirty environment. Check monthly in all cases.
The filter is located on the lamp side of the projection head, near the front.
See Figure 4.4.
Power down and disconnect from AC
'
Follow steps 1-3 from the Lamp Replacement Procedure, above.
Open/remove filter door
'
Loosen 2 corner screws (flat screwdriver), and lift off door.
Replace air filter
'
Slide the old filter down-and-out and discard. Insert the new air filter, following the
labeling for proper inside/outside orientation. Slide all the way up, under top tabs.
Close/replace filter door
'
With the filter in place, insert the bottom tabs of the filter door into the corresponding
slots, close the filter door, and secure with 2 screws.
(or on the standard remote keypad) to record the number
Enter
WARNING
Use only Christie filters. Never operate
the projector without the filter installed.
MAINTENANCE
Roadie 25K User's Manual
4-11