Christie roadie 25k User Manual page 42

INSTALLATION AND SETUP
2-36
Roadie 25K User's Manual
Remember, for either configuration in
Figure 2.38, make sure to segregate the
networks from one another by selecting the
"Separate" option for "Network Routing" in
the Communications menu.
NOTE: When connecting RS422 to a projector, use either of the identical rear ports
(6-pin XLR) or the 9-pin "RS422 IN" port on the side input panel.
Figure 2.38. Sample Hardware Setups for Split Networks
Whenever downloading new projector software to networks, use a
single-route RS232 network only. DISCONNECT any redundant serial
cabling and Select "Separate" for "Network Routing" in each projector.
IMPORTANT