Christie roadie 25k User Manual page 54
Hide thumbs
Also See for roadie 25k:
- Specifications (2 pages) ,
- User manual (191 pages) ,
- Instruction sheet (9 pages)
Table of Contents
Advertisement
INSTALLATION AND SETUP
2-48
Roadie 25K User's Manual
•
Replace battery compartment cover.
•
Plug into the 3-pin XLR port at the rear panel of the projector.
TO CHANGE FROM WIRED TO INFRARED:
•
Unplug the keypad from the projector.
•
Open the keypad back and unplug the keypad cable.
•
Wait 1-2 minutes.
•
Install batteries (see Section 4).
•
Set jumpers according to the desired IR protocol (refer back to Figure
2.53). Make sure to set jumper #4 between pins 1 and 2 as shown for all
remote protocols.
•
Replace battery compartment cover.
Advertisement
Table of Contents
