Christie roadie 25k User Manual page 63

OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
NOTE: You must have an unlocked channel present to use Auto Setup.
Press to display summary information about the current menu or highlighted
Help Help
menu option. Or, if there is no menu present, press
help topics. To exit any help text, press
Channel
Chan
Press to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust animage from a new source.
NOTE: key behavior during a presentation depends on whether or not the
Chan
Display Channel List option is enabled in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
Input 1
Input 1
Press to display from the data input source connected to BNCs labeled
Input 1
Input 2
Input 2
Press to display from the DVI source (analog or digital) connected to
Input 2
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
Input 5
Input 5
Press to display from the
Input 5
which is typically the standard factory-installed Dual SD/HD-SDI Module. Note that
if there are two inputs connected to this module, the second input (B) is considered
INPUT 7
and can be most easily accessed with
in keypad or the optional "lite" remote keypad, neither of which have a separate
INPUT 5
key, use to access
•
While displaying from
Table 3.1. Auto Setup
What an "Auto Setup" Does
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
again (or
Help
), the display will automatically change and update
INPUT 5
interface module installed in the Option 1 slot,
Input
INPUT 7
as follows:
INPUT 5
, press
Input 5
OPERATION
to access a list of general
Help
).
Exit
, or you may prefer to
Chan
INPUT 3
INPUT 4
.
. Or, if you are using the built-
INPUT 7
again. This switches to
Roadie 25K User's Manual
INPUT 1
.
INPUT 2
.
.
Input
.
3-9