Christie roadie 25k User Manual page 94

OPERATION
Figure 3.17. Using the "Network Routing" Option
RS232 AND RS422 JOINED:
Messages to and from any serial port will also be relayed
to all other serial ports. Use when there is only one physical link between any two
projectors, but which might be RS232 or RS422.
RS232 AND ETHERNET JOINED:
Messages to and from the RS232 ports will also be
relayed to the Ethernet port, and vice versa. Any RS422 communications will be
isolated.
ALL JOINED:
All messages reach all ports.
Ethernet Settings
(SUBMENU)
NOTES: 1) Not used for stand-alone projectors. 2) Recommended for network
administrators only.
DHCP:
Enable this checkbox if you want a DHCP server to automatically change the
projector's default IP address (0.0.0.0) to one that is valid and unique for use on the
current Ethernet network. On networks without a DHCP server, or to simply override
the automatic DHCP server function, delete the checkmark and enter the new "IP
Address" settings desired. Remember that only a 0.0.0.0 address will trigger the
DHCP addressing service, and only when the DHCP checkbox is enabled.
IP ADDRESS:
Enter a valid and unique IP address for use on the network to which the
projector is currently connected. Upon the next power-up, this address will overwrite
any previous IP address such as the projector's factory-defined default (0.0.0.0), or
one that has been assigned by a DHCP server or other user. An IP address entered
here remains in effect until it is changed again. NOTES: Make sure the projector is
connected to the network before changing its IP address. Make sure to re-boot.
3-40
Roadie 25K User's Manual