Christie roadie 25k User Manual page 123

Table 3.6. System Error Codes
Code Description
GENERAL
12 Software error. Contact dealer/factory.
13 CRC error in flash ROM. Download new software.
14 Engineering-only programming is complete. Call Christie, replace TIPM.
15 Attempting to download s/w code without being in boot mode
16 Invalid interrupt. Power off/on. If persists, contact dealer/factory.
17 User has forced system to stay in boot mode
18 Attempting to program boot mode without jumper
LAMP / BALLAST
20 The lamp is unexpectedly on (likely a ballast and/or wiring problem)
22 One or more high-current lamp cables is not connected
26 Lamp door is open (interlock)
27 Lamp cannot ignite
28 Lamp has turned off unexpectedly
29 Lamp ballast is overheated
2C Lamp communications fault; ballast is not detected
SENSORS for COOLING
40 Lamp has shut down due to fan failure
46 The red TEC (DMD) has overheated
48 The blue TEC (DMD) has overheated
49 The prism has overheated
4C Projector has shut down due to critical error
4D Integrator has overheated
4E Inadequate lamp air intake rate (interlock)
4F Inadequate air exhaust rate (interlock)
FANS (note: there are no Fans 1 or 2 in this projector)
53 Fan 3 has failed (side [rear] intake fan)
54 Fan 4 has failed (side [front] intake fan)
55 Fan 5 has failed (lamp exhaust fan)
56 Fan 6 has failed (LAD fan)
57 Fan 7 has failed (card cage fan)
58 Fan 8 has failed (heat exchanger fan — for liquid cooling system)
10-bit IMAGE PROCESSOR (TIPM)
60 Boot code CRC failed
61 Unable to program the DigMux PLD
62 Unable to program the Control PLD
63 Unable to program the Bubks PLD
64 Unrecognized ROM type
65 Write to flash ROM failed
66 General TIPM failure
67 Downloaded code will not fit into ROMs
68 Communication error with scaler on TIPM
BUILT-IN KEYPAD or ID EEPROM
70 Unable to access the built-in keypad EEPROM
71 EEPROM on the built-in keypad has re-initialized
IRAM (a.k.a. Panel Driver) or IRAM/TIPM Communications, or EFIB or Modular Formatters
80 Unrecognized IRAM (a.k.a. Panel Driver)
81 Unable to program a device on the IRAM
82 TI flash download fault — critical error
83 TI flash download fault — partial success
84 TI flash download fault — partial success
2
85 TI I C fault (write failure)
87 Consecutive faults from modular Formatters
90 Red modular Formatter link failure
91 Green modular Formatter link failure
92 Blue modular Formatter link failure
93 Modular Formatter Architecture error
94 Modular Formatter / DMD mismatch
95 Modular Formatter sequence mismatch
96 EFIB not responding to I
BACKPLANE OR OPTIONAL MODULES
A0 Unable to program the optional interface module
A1 Unable to power the optional interface module
A2 Unable to program the Backplane
A3 Unable to program the Warp Module option (ChristieTWIST)
Exit
Clear system errors with
again (cooling if necessary). For detailed information, monitor the RS232 IN port. Contact
dealer/factory if error persists. Codes omitted from this table should not appear in your projector.
2
C messages
Exit
. If necessary, try resetting the projector by powering it off and on
OPERATION
Roadie 25K User's Manual
3-69