Installation & Setup; Quick Setup - Christie roadie 25k User Manual

This section explains how to install, connect, and optimize the projector for smooth operation. For more
comprehensive instructions and operating details, refer to the remaining sections of the manual.
2.1

Quick Setup

STEP 1
STEP 2
STEP 3
STEP 4
Installation & Setup
Follow these steps for quick setup of the projector in a basic front mount position.
Position the Projection Head
'
Locate the projection head at an appropriate throw distance (projector-to-screen
distance) and vertical position. See 2.3, Projector Position and Mounting and
Appendix D. Make sure that the projector is level from side-to-side, and do not invert.
Locate the lamp ballast so that its 4 cables can reach the rear of the projection head.
Install Lamp, Lens and Heat Extractor
'
Refer to 2.4, Installing a Lens, Lamp & Cooling for instructions.
Connect a Source
'
Connect your desired source to the
appropriate connector(s) on the main
input panel located on the side of the
projector (lens side).
Connect to Lamp Ballast and Power
'
• Connect all 4 cables to the projection head prior to
HEAD-TO-BALLAST:
communication/control cables—between the projector rear and lamp ballast.
See Figure 2.1.
WARNINGS
turning the ballast breaker on.
• Follow all labeling exactly.
Connect all 4 ballast cables—two DC power cables, and 2
S e c t i o n 2
Roadie 25K User's Manual
2-1