Operation On A Pabx - Siemens Gigaset Euroset 5015 Quick Manual

Changing the PIN
c?M9
Lift handset, initiate function.
o
Enter the current PIN (default setting: 0000).
o
Enter a new PIN (four digits).
o
Enter the new PIN again to confirm.
?a
Press the Set key. Replace the handset.
Call duration display
The telephone can display the approximate call duration in
the display (up to 99 min. 59 sec.). If the call duration dis-
play is activated, the time display begins 12 seconds after
the last digit is dialled.
Resetting the counter
After dialling the first digit or at any point during a call:
N
Press the Reset key.
The counter goes back to 0 min. 0 sec.
Deactivating/activating
The call duration display is activated by default.
c?18#
Lift handset, initiate function.
0 1
/ 0: deactivate; 1: activate.
?a
Press the Set key. Replace handset.
Setting the pause time
If necessary, the pause time of the Pause key
function from second input position) can be changed to 1,
3 or 6 seconds (default setting: 3 seconds).
c?102
Lift handset, initiate function.
0 2
... 0: 1 sec.; 1: 3 sec.; 2: 6 sec..
?a
Press the Set key. Replace handset.
Changing the dialling mode
c?#
Lift handset, initiate function.
1 2
/ 1: Tone dialling.
2: Pulse dialling without flash function.
?a Press the Set key. Replace handset.
5
EN
Changing dialling modes during a call
If your telephone is set to pulse dialling and you want to use
functions that require tone dialling (e.g. remote access to
an answering machine), you can change the dialling mode
during a call.
*
o
The telephone is reset to the original dialling mode by hang-
ing up the handset.

Operation on a PABX

Enter/delete an external line prefixe
If you are using your telephone on a PABX, you may have to
save one or more external line prefixes. A dialling pause is
set automatically with the external line prefixe. You can save
up to three external line prefixes.
c?0
<
(pause
?a
o
; o
?a
Recall key (on a PABX)
During an external call, you can make a recall or divert the
call. To do this, press the Recall key
procedure depends on your PABX. By default, the Recall key
is preset to a flash time (interruption time) of 90 ms for use
of new features on public telephone systems. With a
connection to a PABX, it may be necessary to change the
flash time (e.g. 600 ms). To do this, please refer to the
operating instructions for your PABX.
With an open connection: press the star key.
Enter digits for remote control/data transfer.
Lift handset, initiate function.
If no external line prefixe has been set in a
location, z appears in the display.
If several external line prefixes are saved, these
are displayed next to one another; the current
external line prefixe to be edited flashes.
;
If necessary, use the
between the external line prefixes displayed,
to edit them as follows:
To delete an external line prefix:
Press the Set key. Replace handset.
To enter an external line prefixe:
Enter a one- to three-digit code.
Enter additional external line prefixes:
Press the Last number redial key, enter next
external line prefixe.
Press the Set key. Replace handset.
>
key to toggle
. The subsequent