Stopping The Sounders; Panic Buttons; Ambush Code; Technical Troubles Review - Teletek electronics ECLIPSE 8 User's Operation Manual

ECLIPSE 8/16/32/99 Series – User Operation Manual

3.4 Stopping the Sounders

A triggered alarm can be stopped by entering a valid user code or a valid user card placed
in front of the proxy reader.
Note: The user code must have assigned rights to operate with area where the alarm
event is triggered off the sirens.

3.5 Panic Buttons

By using a combination of buttons, the user can send an alarm signal without triggering
the siren off. To send an alarm signal:
• For "FIRE ALARM" signal, press and hold the 7+9 buttons for 2 seconds.
• For "MEDICAL ALARM" signal, press and hold the 4+6 buttons for 2 seconds.
• For "PANIC ALARM" signal, press and hold the 1+3 buttons for 2 seconds.

3.6 Ambush Code

Ambush code is a system code which is used to disarm the system, but it also sends an
"alert" signal to the monitoring station. It is used when the user is forced to disarm the
system.
The Ambush code is formed by increasing the last digit of the user's personal code by 1.
If the last digit is 9, it is replaced by 0.
Personal code: 4615 → Ambush code: 4616
For example:
Personal code: 4619 → Ambush code: 4610

3.7 Technical Troubles Review

In case of system fault the "TROUBLE" button lights on permanently. On the LCD
keyboards text message "Trouble [TRBL]" is displayed.
To review the system faults, press the "TROUBLE" button. In TROUBLE MODE viewing
the "TROUBLE" button starts blinking. To exit TROUBLE MODE, press "CANCEL" button
or wait 30 seconds for the system to leave this mode automatically.
For LED 8 and LED 16A keyboards the system faults are indicated with permanently lit
TROUBLE LED. To review the system faults, single press the "ENTER" button.
The indication for system fault will stop automatically after the fault is restored.
The system faults are displayed with permanently lit on number on the LED display and
with a text message on LCD displays. The text messages are displayed one by one or
can be scrolled manually with the arrows.
To stop the sound signalization for system fault, enter in sequence:
For LED 32/LCD 32/LCD 32S For LED 8/LED 16А
User
User
Code
Code
18