Optional Central Station (Psc-5S) - Hitachi FSG1 Series Technical Catalogue

REMOTE CONTROLLERS OPERATION
11
/18

11.5 OPTIONAL CENTRAL STATION (PSC-5S)

Model:
Order No:
É
Indication of Fan speed
It indicates the fan speed selected to group shown:
High/Medium/Low
Ê
Mode Indication
It indicates the operation Mode selected to group
shown: Fan, Cool, Heat and Dry.
Auto is available if this function is activated
Ë
Run indicator (Red Lamp)
Ì
RUN/STOP Switch
Operation Status of each unit is changed, ON/OFF
Í
Operation mode Selection Switch
FAN, COOL, HEAT, DRY
Î
Fan Speed Selection Switch
HIGH, MEDIUM, LOW
Ï
Timer Selection Switch
By depressing this switch, the signal from the Control
Timer (PSC-5T) schedule is available and the "TIMER"
indication is turned on. Depressing again "TIMER" is
turned off and schedule is not available.
Ð
RMT.SW AVL/NAVL Switch
By depressing this switch, control by each Remote
Control is prohibited or not.
When "RMT.SW NAVAL" is indicated Remote Control
Switch is prohibited.
NOTE:
When monitoring mode is selected, the above
mentioned operation modes and setting
temperature are indicated.
Ñ
LOUVER (Swing Louver Operation) Switch
By depressing this switch the swing louver position or
operation is selected
PSC-5S1
60299729
Ò
Temperature Setting Switch
Ó
This Switch is not used
Ô
Check Switch
By depressing this switch, "CHECK" is indicated and
Master or Slave unit can be set. See sub-chapter 16.3.5
for more details.
Õ
RESET Switch
By depressing this switch, the CHECK function is
canceled. The "FILTER" indication can be turned off
too.
Ö
Group Selection Switch
By depressing this switch, the group number to be
controlled is changed from 01 to 16. After 16, AA is
shown, and then all the units are controlled
simultaneously. Depressing again 01 is shown and
sequence is started
×
CHECK, FILTER, RMT. SW NAVAL and ABNML
indication
"CHECK" is indicated when that Switch is depressed.
"FILTER" is indicated when one or more units of the
same group have the filter clogging.
"RMT.SW NAVAL" is indicated when that switch is
depressed.
"ABNML" is indicated when one or more units of the
same group selected have an abnormal condition.
Ø
TEMPERATURE indication
Ù
TIMER, DEMAND, EMERGENCY and NO FUNCTION
indication
"TIMER" is indicated when that switch is depressed.
"DEMAND" is indicated when the demand input is set
by the outside input function.
"EMERGENCY" is indicated when the emergency stop
signal is input from the outside input function.
"NO FUNCTION" is indicated when switch depressed is
not available
Ú
Group Operation
The "n" mark shows the operation conditions of each
group.
" " OFF is Stop,
"n" ON is Operation and Flickering is abnormality.
Û
Group Number Indication
Ü
Check Model Number indication
Ý
Swing Louver Indication
When opening the cover, pull the cover toward the
arrow direction