Optional Functions Available Through Wireless Remote Control Switch (Pc-Lh3 + Receiver); Optional Functions Available Through Wireless Remote Control Switch (Pc-Lh3A + Receiver); Optional Functions; Setting Of Sub-Receiver Part - Hitachi FSG1 Series Technical Catalogue

AVAILABLE OPTIONAL FUNCTIONS
10
/26
10.6. OPTIONAL FUNCTIONS AVAILABLE THROUGH WIRELESS REMOTE CONTROL SWITCH
(PC-LH3A + RECEIVER)

10.6.1. OPTIONAL FUNCTIONS

The following optional functions can be set by the dip
switches of the receiver part.
§
PC-RLH4
Optional Function
1
#
Standard
¡
100 hours
Filter
#
1200 hours
Option
¡
2500 hours
¡
No indication
Muffing Buzzer Sound -
Removal of Heating
-
temperature Calibration
Circulator Function at Heating
-
Thermo-OFF
Setting of Sub Receiver Part -
¡ #
-
: ON : OFF :ON or OFF booth available
§
PC-RLH9/11
Optional Function
Setting of Sub Receiver Part
&
CAUTION:
Turn OFF all the power sources before setting the dip
switches
10.6.2. OPTIONAL FUNCTION DESCRIPTION
§
Change of Filter Cleaning Time
The filter sign (LED; Yellow) of the receiver part is set to
turn ON after the total operation period is over 1,200
hours approximately (Factory-Setting). (In case of the
RPK model, the factory-setting is 200 hrs.) However, this
filter cleaning time can be changed depending on the
condition of the filter.
§
Removal of Heating Temperature Calibration
Refer to 10.4.2 (1) for the details.
§
Circulator Function at Heating Thermo-OFF
Refer to 10.4.2 (2) for the details.
§
Setting of the Optional Functions PC-RLH9/11
The following optional functions can be set by the dip
switches of the receiver part.
1 Setting of Main and Sub Receiver Part
2 Identifying of Indoor Units Installed Side By Side
Dip Switch
2 3 4 5 6 7
# #
- - - -
# #
- - - -
#
¡
- - - -
¡ #
- - - -
¡ ¡
- - - -
¡
- - - - -
¡
- - - - -
¡
- - - - -
¡
- - - -
Dip Switch
1 2 3 4
¡
- - -
§

Setting of sub-receiver part

For this optional function set pin marked with É to ON
PC-RLH4
a. Open the cover of the receiver part as indicated below.
8
-
-
-
-
-
-
-
-
-
PC-RLH9/11
Open the lid of case by removing two screws so that the
following functions are available.
§
PC-RLH9
Switch (COOL)
Switch (HEAT)
§
PC-RLH11
Switch (COOL)
Switch (HEAT)
DIP Switch (SW3)
É
DIP Switch (SW3)
Hole for Cable
Cover
Printed Circuit Board
Hole for Cable
É
Printed Case
Cover
Circuit Board
7-Segment
Remove two screws
and open the case
Case
1. Remove the base.
2. Remove two crews
and open the case
Base