Harc; Name Of Parts; Installation Procedure - Hitachi FSG1 Series Technical Catalogue

16.8 HARC

16.8.1 NAME OF PARTS

Name of each part of HARC-BX E is diplayed in the figure
below.
n Board
¥
8P DSW No. 2 (S202) (***): Dip Switch for setting
Functions of HARC-BX E .
¦
Power Source Display LED (PWR): Light is ON when
the pòwer is supplied.
§
Transmission Display LED (H-L): Transmission state
with H-LINK
¨
Transmission Display form Upper System LED
(LON): Transmission state with Upper Monitoring
Equipment
(*) 7-Segment:
Read 4.2 "Test Run" 4.3 "Abnormal Indication" for the details of 7-
Segment's display.
(**) 8P DSW No.1 S201:
Read 4.1 "Setting of Dip Switch" for the detail and function of
HARC-BX E .
(***) 8P DSW No.2.S202:
Read 4.1 "Setting of Dip Switch".8P DSW No.1 and No.2 are used
for self-inspection. for details, refer to the 5.1 "Self-Inspection of
HARC-BX E ".
INSTALLATION OF OPTIONAL REMOTE CONTROLLER
¡
Power Source Terminal
to conect to
AC220~240V Power
Source
¢
Earth Terminal to be
ground
£
Terminal Board for Unit
Transmission to connect
H-Link
¤
Terminal Board for Upper
System, to connect
Transmission Line for
Upper System Monitoring
¡
PSW No. 1 (M.CLR):
Push Switch for checking
connected unit quantity
¢
7-Segment (*): Present
state of HARC-BX E
£
PSW No.2 (LON-SERV):
Push Switch for
transmission neuron ID.
(Service Pin)
¤
8P DSW No. 1 (S201)
(**): Dip Switch System
Setting of HARC-BX E

16.8.2 INSTALLATION PROCEDURE

1. Install the HARC-BX E by keeping the screw terminal
board at the lower side.
Upper
Downward
O O O O
Correct Incorrect
2. Fixing Method by Screw(M4) (Screws: Field-supplied)
By using screw (M4 Screw, 4Position), fix HARC-BX E on
the wall.
16
/27
(Horizontal
Installation)
# # # #
O O O O
Correct