Input/Output Function - Hitachi FSG1 Series Technical Catalogue

INSTALLATION OF OPTIONAL REMOTE CONTROLLER
16
/14

16.3.5 INPUT/OUTPUT FUNCTION

The central station has two input functions and two output
functions as shown below
Input/Output Setting Mode and Connector
ON
Mode Port
1 2 3 4
Simultaneous Operation /
Input 1 CN2 1-2
Stoppage Level Signal
Input 2 CN2 2-3 Demand
Output 1 CN3 1-2 Simultaneous Operation Output
Output 2 CN3 1-3 Simultaneous Alarm Output
Specification of Required Components:
- DC12V Non-Voltage A Connection
- OMRON MY Relay
- PCC-1A
1 Simultaneous Operation / Stoppage Level Signal
This is an ON/OFF function from a remote place by using
level signal (ON/OFF)
The basic wiring and time chart are shown below.
I
Time Chart
Signal to 1 & 2 of CN2
Control by R.C.S.
Unit Operation
Setting of DSW2
ON ON
1 2 3 4 1 2 3 4
Simultaneous
Operation,
Pulse Signal
Simultaneous
Emergency Stop Stoppage,
Pulse Signal
Time
2 Simultaneous Operation, Pulse Signal and
Simultaneous Stoppage, Pulse Signal:
This is an ON/OFF function from a remote place by using
pulse signal
The basic wiring and time chart are shown below.
CN2
I
Time Chart
Signal to 1 & 2 of CN2
Signal to 2 & 3 of CN2
Control by R.C.S.
Unit Operation
3 Emergency Stop
This is an emergency OFF function from a remote place
by using pulse signal. All units controlled with central
station are forced to stop and further setting with R.C.S.
is not enabled until emergency OFF is removed,
The basic wiring and time chart are shown below.
CN2
I
Time Chart
Signal to 2 & 3 of CN2
Control by R.C.S.
Unit Operation
OFF
ON
Time
S1
Time