Fsg - Fxg - G7 - Hrg - Usb/H-Link Connection - Hitachi FSG1 Series Technical Catalogue

INSTALLATION OF OPTIONAL REMOTE CONTROLLER
16
/30
16.9 FSG - FXG - G7 - HRG – USB/H-LINK CONNECTION
n n n n HARC40 WITH USB Connection
As a result of ISA Board connections being phased out of
Computer design, an external Interface with a USB
connection, has been developed for H-Link connection to
the CS-NET. This also makes the application more flexible
in that it can be connected to a portable computer enabling
a service engineer to monitor systems which are not
connected to a CS-NET software.
The Installation must be carried out as detailed below.
?
NOTE:
All cables must be shielded and at least 0,75 mm²
cross section. Maximum length is 1000 m.
n n n n Installation
Install CS-NET program before start HARC installation.
Switch the computer off.
Connect the HARC40 Interface to the computer using the
USB connection cable.
Switch the computer on. Windows will automatically detect
that the Interface is connected and that the device
"HARCUSB" is available at the CD/CDROM. Windows will
automatically terminate the installation of the device.
Connect the CS-NET cable on the Interface to the H-Link
connection on any one of the indoor or Outdoor Units.
n n n n Interface Connections
The connections available for the Interface are as follows:
Terminal Board TB1 (See diagram opposite)
1. Main H-Link connection for 2-core cable to the system.
2. USB connection to the USB port on the computer.
The power supply for the HARC40 is taken through the
USB connection so no external supply is necessary.
Rear View Of HARC40 Inter face
TB
1
H-Link
USB
Connection
n n n n HARC40 Interface Layout
The Layout of the HARC40 Interface printed circuit board,
as viewed from the underside, with the Dip Switch positions
and connections, can be seen opposite.
The Dip Switch DSW1 must be set if more than one
Interface is installed. See Page 10 of this section for the
settings.
DSW2 must not be changed.
H-Link to
Input
System
n n n n Led Indicators
POWER Continuously lit when power from computer is
applied
USB Blinks when transmission is available between
Computer and Interface
H-Link Blinks when transmission is available between
Interface and the system
HARC1 Communication state (Not Used)
HARC2 Communication state (Not Used)
Power
USB
H-Link
HARC1
HARC2
USB
Connection
S2
DSW2
DSW1
S1