Other Indications; In Normal Condition; Central Control; Motion Sensor Control - Hitachi RPC-5.0FSR Operation Manual

10. Other Indications

10.1 In Normal Condition
10.1.1 Central Control
• When remote control operation is restricted
(all functions)
"Central Control" and " " are turned ON.
If the remote control restriction is set from
the central controller, the settings for RUN,
Operation Mode, Temperature Setting,
Fan Speed and Louver will not be accessible
from the controller.
• When remote control operation is restricted
(some functions)
" " is turned ON.
The function operation which is restricted from
the central controller cannot be set.
10.1.2 Motion Sensor Control
"Motion sensor ON" is turned ON during the
motion sensor control.
In this case, the operation is performed with
saving the capacity or stopped by the motion
sensor control.
Meeting Room
A/C
MODE SPEED
HEAT
Motion Sensor ON
SPEED
Turned ON
A10762290A
Turned ON
Turned ON
LOUV. TEMP
20
.0
Adj.

10.1.3 Defrost

"Defrost" is turned ON and the indoor fan stops
during defrosting operation. The louver is fixed in
a horizontal position.
Turned ON
• Operation Stoppage during Defrosting Operation
If the unit operation is stopped during defrosting
operation, the operation continues with the RUN
indicator (Green) turned OFF. The operation
stops after defrosting operation.
10.1.4 Operation Control
• Supplying Main Electrical Power
"Preheating" is turned ON at power-on.
In this case, the compressor is under preheating.
Do not turn OFF the power supply of the outdoor
unit during the high season for Cooling/Heating
operation. Otherwise, the operation might not be
available for Max. 4 hours.
Turned ON
• During Hot Start (for Heating Operation Only)
"HOT-START" is turned ON.
Turned ON
13