Installation Of; Installation Of Remote Control Switch (Core-Function) <Pc-P5H - Hitachi FSG1 Series Technical Catalogue

INSTALLATION OF OPTIONAL REMOTE CONTROLLER
16
/6
Address of Indoor Units:
Main unit
th
4 unit
16.2 INSTALLATION OF REMOTE CONTROL SWITCH (CORE-FUNCTION) <PC-P5H>
n
Selection of Installation Place
§ Select a suitable place for handling and determine the
installation place of the controller with the customer's
acceptance.
§ Do not install the controller at such places as:
– Where children can touch
– Where the air from the air conditioner is directly
discharged
n
Before Installation
Check the contents and the number of the accessories in
the packing.
Remote Control 2 screws
Switch, for Ø4x16L
Operation Control For fixing the
Holding Bracket
onto the wall
n
Installation Space
§ In case of installing the controllers in vertical line, keep
a distance more than 50mm between the controllers
vertically.
If the distance is insufficient, the front cover of the
controller can not open wide enough.
st nd rd
1 unit 2 unit 3 unit
th th th
5 unit 6 unit 7 unit
Ring Band Cable
Core1 For fixing (20 cm)
Cable to
Ring
Core
More than
50 mm
th th th
8 unit 9 unit 10 unit
th th th
12 unit 13 unit 14 unit
n
Installation Procedures
1. Insert the edge of the screwdriver into the groove parts at
the bottom of the holding bracket, push and turn the
screw driver and remove the controller from the holding
.
bracket
Groove Part
2. Connection of cable.
Connect the accessory cable to the fielded cable by
soldering.
Accessory Cable
(Insulate the connecting part by vinyl tape)
3. Attach the controller to the holding bracket and connect
the cable as follows.
In Case of Exposing Remote Control Cable
th
11 unit
th
15 unit
Figure seen from Bottom Side
Approx. 6 mm
Screw Driver
Field Supplied Cable
Fix the Holding Bracket onto
the wall with screws
(Accessory)