Hitachi FSG1 Series Technical Catalogue page 265

§ Hoods for RAS-16FSG, RAS-20FSG/FXG1
- Air Discharge Hood
- Air Intake Hood
13-Ø7
Make additional
5-Ø3.8mm holes
on the rear panel
of the unit
11-Ø7
Make additional
4-Ø3.8mm holes
on the side panel
of the unit
Side Hood (RAS-16FSG)
Steel Plate
with Holes
REAR HOOD
Steel Plate
11-Ø7
with Holes
Make additional
4-Ø3.8mm holes
on the side panel
of the unit
UNITS INSTALLATION
Set this part 10mm
away from the end of
the cabinet
Make 20-Ø3.8mm
holes on the side
panel of the unit
PART P
Steel Plate
with Holes
Side Hood (RAS-20FSG/FXG1)
12
Set this part 10mm
away from the end of
the cabinet
HOLE FOR HOOD PART
/35