Sensor (Adf Media Exit) Late Jam Service Check - Lexmark X651de Service Manual

Sensor (ADF media exit) late jam service check

Use this procedure for the following jams:
• 291.02
Step
1 Check the original document condition.
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes or excessive
wear?
2 Check the media path for contaminates.
Is the media path free of excess media dust and foreign
objects such as paper clips and staples?
3
Check the sensor (ADF media exit) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Observe the line "sensor (ADF media exit)
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
4
Check the sensor (ADF media exit) for proper connection.
Is the above component properly connected?
5 Check the ADF transport drive motor assembly for proper
connection.
Is the above component properly connected?
Check Yes
Go to step 2. Remove damaged
original document
and replace with a
new undamaged
original document.
Perform a ADF
test. If the problem
remains, go to
step 2.
Go to step 3. Remove all
contaminates from
the media path.
Go to step 5. Go to step 4.
Replace the Replace the
sensor (ADF connection.
media exit).
Go to Go to
"Sensor (ADF
media exit) fan
bracket
assembly
removal (models
X652, X654,
X656, and X658)"
on page 4-87 or
"Sensor (ADF
media exit)
bracket
assembly
removal (X651)"
on page 4-88.
Replace the ADF Replace the
transport drive connection.
motor assembly.
Go to "ADF
transport drive
motor bracket
assembly w/
cable removal
(models X651,
X652, X654,
X656, & X658)"
on page 4-74.
Diagnostic information
7462
No
2-129