Full-High Drive: No Apparent Failure Or Damage To Tape - IBM TS3100 Setup, Operator, And Service Manual

Figure A-18. Rewinding tape into cartridge
3. Turn the supply reel ( 4 ) clockwise.
4. Continue spooling into the cartridge until the tape is taut and remains within
5. Go to "Ending Procedure" on page A-25.

Full-high Drive: No Apparent Failure or Damage to Tape

Note: If the cartridge in the drive is an INPUT tape containing ACTIVE or 'ONLY
1
1
Loader motor worm gear
2
Outer guide rail
(WARNING: Do Not Touch)
the flanges of the tape guiding rollers. Turn the supply reel ( 4 ) 10 turns.
Ensure that you do not stretch the tape.
COPY' data (i.e., there is no backup), eject commands issued at the host fail
to unload the tape, and power-cycling the drive fails to eject the cartridge,
make no further attempts to unload this tape. Call Technical Support and
open a PMR if one isn't already open, to initiate the process of sending the
drive with the loaded cartridge in for recovery.
1. Set the drive on its left side with the head and tape path facing up.
2
4
3
4
Appendix A. Information for Trained Service Personnel
3
Takeup reel motor
Supply reel motor
A-19