Full-High Drive: Tape Pulled From Or Broken Near Leader Pin - IBM TS3100 Setup, Operator, And Service Manual

1. From the takeup reel, pull an arm's length of tape around the rear of the tape
2. Set the drive on its left side with the head and tape path facing up.
3. Ensure that the tape is not twisted. Untwist the tape if required.
4. Moisten a cotton swab with water and wet approximately 13 mm (0.5 in.) of
5. Turn the supply reel ( 4 ) clockwise, allowing the moistened tape to adhere to
Figure A-8. Rewinding tape into cartridge
6. Continue spooling into the cartridge until the tape is taut and remains within
7. Go to "Ending Procedure" on page A-25.

Full-high Drive: Tape Pulled from or Broken near Leader Pin

path and over the head and rollers on the left side of the drive.
the tape end and feed it onto the supply reel (inside the cartridge).
the hub as it winds around the supply reel (inside the cartridge).
1
1
Loader motor worm gear
2
Outer guide rail
(WARNING: Do Not Touch)
the flanges of the tape guiding rollers. Turn the supply reel ( 4 ) 10 additional
turns. Ensure that you do not stretch the tape.
2
4
3
4
Appendix A. Information for Trained Service Personnel
3
Takeup reel motor
Supply reel motor
A-9