Figure 4-12. 2U library side screws to remove
6. Install the library mounting brackets ( 1 ) as shown on the 2U library on each
7. With library rack anchors and mounting brackets installed, slide the library
Figure 4-13. Sliding the 2U library into the rack
4-12
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
side of the library using the screw that was removed from your library and an
additional short, counter-sunk screw included in the rack kit. (The 4U rack
anchors and mounting brackets are similar.)
onto the rails (as shown in Figure 4-13 and Figure 4-14 on page 4-13). Gently
push the library into the rack to lock the REAR anchors installed on each side
of the library. When the library stops, the front mounting brackets will be flush
with the vertical rack rails.