A Library Controller Card Being Removed From The Library - IBM TS3100 Setup, Operator, And Service Manual

If the message "VPD Selection" is displayed at the Operator Control Panel,
carefully highlight the "VPD from Enclosure" option to copy that version of the
VPD to the new Library Controller Card. Then continue with the procedure.
Removal and Replacement
Figure 10-13. A Library Controller Card being removed from the library
10. After power is restored to the Library Controller Card, the library will
11. Upgrade library firmware and drive firmware to the latest version. See
12. Run the Library Verify test (refer to "Service: Library Verify" on page 5-30).
1. Power OFF the library by pressing and holding the power button at the front
of the library for 4 seconds.
2. Disconnect the power cord from the electrical source, then from the power
supply or supplies at the back of the library.
3. Loosen the two blue captive thumbscrews on the Library Controller Card.
4. Grasp the two thumbscrews and pull the defective Library Controller Card
out of the library.
5. Remove the packaging from the replacement Library Controller Card.
6. Grasp the two thumbscrews and push the replacement Library Controller
Card into the library.
7. Tighten the two blue captive thumbscrews on the Library Controller Card.
8. Connect the power cord to the power supply or supplies at the back of the
library, then to the electrical source.
9. Power ON the library using the power button on the front panel.
automatically restore the VPD on the new Library Controller Card from the
Library Enclosure. If a "VPD Selection" message is displayed in the Operator
Control Panel, see the "Read Me before Continuing" section earlier in this
procedure to determine how to respond to the message.
"Service Library: Upgrade Firmware" on page 5-74.
Note: Use care when selecting the appropriate VPD to restore from/to. An
error in selection here could cause a long downtime.
Chapter 10. Check, Adjust, Remove, and Replace
10-13