Service Library: Perform Diagnostics Page - IBM TS3100 Setup, Operator, And Service Manual

Note: The Web User Interface System Status screen will indicate progress and
Figure 5-68. Service Library: Perform Diagnostics page
The first field can be modified to set the number of cycles. The second field
displays the cycles completed.
Service Library: Key Path Diagnostics
Important: Ensure that library firmware and drive firmware are up to date before
The key path diagnostics test provides the ability to perform diagnostics on the
encryption key path. Only drives that are set up for library managed encryption
will be tested. Only encryption capable drives in logical libraries that are
configured for Library Managed Encryption will be tested. To configure the library
for encryption, refer to "Configure Library: Encryption" on page 5-47.
The test consists of four parts:
v Drive Test: The library performs a drive communication test to confirm
v Ethernet Test: For each EKM IP address, the library performs a ping test and
v EKM Path Test: For each EKM IP address that passed the ping test, the library
v EKM Config Test: This test confirms that a drive is correctly configured in the
To run the Key Path Diagnostic, complete the following procedure.
1. Log on to the Web User Interface. Refer to "Login" on page 2-5.
2. Quiesce all drives, then unload all drives.
3. Click Service Library, then Key Path Diagnostics.
completion of the activity.
running the Key Path Diagnostic. Library firmware level must be
greater than 6.xx. See "Verifying/Updating Firmware" on page 4-21.
communication with the drive.
records the results.
performs an EKM communication test.
EKM to service key requests.
5-73
Chapter 5. Operations