Choosing Your Configuration Method; Using Factory Defaults As Your Configuration; Configuring Your Library Using The Web User Interface - IBM TS3100 Setup, Operator, And Service Manual

For complete detailed configuration information on all of the functions available on
your library using both the Operator Control Panel and the Web User Interface, see
Chapter 5, "Operations," on page 5-1. For default library settings, see "Configure:
Save/Restore" on page 5-26

Choosing Your Configuration Method

If you choose to use the factory defaults for your library configuration, go to

"Using Factory Defaults as Your Configuration."

If you choose to use the Web User Interface for configuring your library, go to

"Configuring Your Library using the Web User Interface."

If you choose to use the Operator Control Panel for configuring your library, go to
"Configuring Your Library using the Operator Control Panel" on page 4-36.
Write down all library configuration settings on the Appendix G, "Library
Configuration Form," on page G-1 for future reference.
Using Factory Defaults as Your Configuration
The table below shows the main default library settings. If you wish to use the
defaults, no other changes need to be made before using your library
For a full list of factory defaults, see "Configure: Save/Restore" on page 5-26.
Configuring Your Library using the Web User Interface
To configure your library using the Web User Interface, complete the following
procedures:
4-18
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
Item
Logical Libraries
Active Slots
I/O Slots
DHCP
Internet Protocol
Bar Code Label Length
Library Mode
AutoClean
Encryption
IPv6 Stateless Autoconfig
1. "Establishing Remote Access to Your Library" on page 4-19
2. "Logging on to the Web User Interface" on page 4-21
3. "Verifying/Updating Firmware" on page 4-21
4. "Choosing General Library Settings" on page 4-22
5. "Choosing the Number of Logical Libraries for Your Library" on page 4-24
6. "Entering Path Failover Feature Activation Key" on page 4-25
7. "Setting Up Encryption" on page 4-26
8. "Choosing Drive(s) Interface Identification/Settings" on page 4-29
9. "Entering Library Network Settings" on page 4-29
Default Setting
1
Maximum
Enabled
Enabled
IPv4 Only
8
Random
Disabled
None
Enabled